Skip to content

Abrasives · 5 min read

How to Choose the Right Abrasive: Grit, Grain and Flap Discs

A practical guide to grit sizes, abrasive grain types and flat versus conical flap discs for grinding, blending and finishing metal.

Choosing an abrasive comes down to three questions: how much material must come off, what finish is needed and what is being ground. Grit, grain and disc geometry answer them.

Grit: coarse removes, fine finishes

  • 24 to 40 grit: heavy stock removal and weld grinding.
  • 60 to 80 grit: weld blending and general smoothing.
  • 120 grit and finer: finishing and preparing a surface for coating.

Grain: what the abrasive is made of

  • Aluminium oxide: the general-purpose grain for mild steel and wood.
  • Zirconia alumina: tougher and self-sharpening, a good fit for stainless steel and heavier grinding.
  • Ceramic: very aggressive and long-lasting on high-pressure work.
  • Silicon carbide: sharp and hard, used on non-ferrous metals, glass and stone rather than steel.

Flap disc geometry: Type 27 or Type 29

A Type 27 (flat) disc runs flat against the work and suits edges and light finishing. A Type 29 (conical) disc is angled, offering a larger contact area for faster stock removal on flat surfaces and welds. Many fabricators keep both in stock.

Safety basics

Always check that the maximum operating speed printed on a disc or wheel is at or above the machine’s rated speed, use the guard fitted to the grinder, and wear eye and hearing protection. Never use a cutting wheel for side grinding.

Need a quotation or help finding the right part?

Send us your requirement, drawing number or a photo of the part you are replacing. We will come back with availability and pricing.